Basic Cleaning - Taurus MERCUCIO Manual De Instrucciones

- Close The turning knob (R) to the right, clock-
wise.
OBTAINING STEAM:
- The steam is used to foam milk for cappuccino,
and also to heat other liquids.
- Turn the appliance on using the on/off button.
- The indicators of 1cup coffee button and
2-cup coffee button flash, the machine begins
preheating, until indicators are solidly ON. The
right temperature for coffee is reached.
- For Steam, press the Steam heating button (H),
with Steam icon flashing, and continue heating
until the steam temperature has been reached.
- The Steam light will illuminate steady, indica-
ting that the water has reached the necessary
temperature for generating steam.
- Note: During operation, the indicator in the
steam selector will cycle on and off to maintain
to desired temperature.
- Place a recipient under the steam tube.
- Open Steam knob (R) anticlockwise
- Steam only will begin to exit.
- When you have enough, close the control and
remove the recipient.
IMPORTANT
- When you finish doing steam, you must replace
the water used to make steam and at the same
time, recover the temperature (lower) to make
coffee.
- To do this, with the steam knob open, pushing
previously over Steam Icon to stop heating,
push coffee / water button (G1 or G2), which
will activate the pump.
- Put a container under the tube
- When water starts to flow through the steam
pipe, it means that it has recovered the coffee
temperature and the boiler has been filled. Now
you can close Steam knob and to push coffee
button (G) to Stop position
AUTO-OFF FEATURE:
- The TAURUS machines are designed to save
energy.
- To that end, after some minutes from the last
operation, the unit switches to energy saving
mode.
- To return to normal operation you should just
Switch ON the connect button (F).
- Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch
(F) for a few seconds
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
CLEANING

BASIC CLEANING

- Disconnect the appliance from the mains and
let it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Neither parts of this appliance are suitable for
cleaning in the dishwasher.
- After washing, dry all the parts before fitting
them together and storing.
CLEANING THE FROTHING WAND
- CAUTION! The frothing wand, and frothing
sleeve may be VERY HOT.
- It is recommended to purge and wipe the
frothing wand after steaming milk to prevent
deposits of dirt and before turning off the
machine.
- To do this, pull the frothing sleeve down and
clean under warm running water.
- Fill a cup with a bit of water, immerse the frot-
hing wand into the water.
- Drain hot water through the pipe, following the
instructions "Obtaining hot water".
- Use a cloth to dry the frothing wand and repla-
ce the frothing sleeve.
- In case no steam comes out of the frothing
wand, hardened milk blocks its path. Carefully
use a needle to loosen the milk residue from
the opening of the frothing tip to remove any
blockage,
- Once clean, rinse with running water from the
tap and reassemble it. Then steam again.