Dismantling The Juice Extractor; Using The Juice Extractor - Cuisinart CJE1000E Manual De Instrucciones

D. Dismantling the juice extractor
1. Unplug the juice extractor
2. Remove the pusher.
3. Press the button in the handle to unlock.
4. Tilt and remove the lid.
5. Gently remove the fi lter by pulling up on one of the sides.
Careful not to touch the blades at the bottom of the fi lter.
6. Remove the foam management fi lter disk.
7. Remove the bowl by pulling up on one of the sides.
16

4. USING THE JUICE EXTRACTOR

1. Make sure that the juice extractor is properly assembled
(Section 3b).
2. Plug the unit into a 230V electrical outlet.
3. Check that the fl ow spout is open. NEVER PRESS FRUIT WHEN
THE POUR SPOUT IS CLOSED.
4. Wash the selected fruit or vegetables.
5. Select the desired speed. The ring of blue light will start to
fl ash.
6. Press the ON/OFF button to start the fruit extractor. The ring of
blue light will remain lit.
7. Lift the pusher and remove it from the feed tube. Insert the
food and push the food using the pusher, pressing fi rmly.
8. Adjust the speed of the juice extractor to suit the food being
pressed. The harder the food, the higher the speed used.
9. The juice will fl ow into the juice pitcher and the pulp will collect
in the pulp container.
10. When all the juice has been extracted, press the ON/OFF
button and turn the speed control to «0» to turn off the juice
extractor.
11. Before removing the juice pitcher, close the pour spout.