Kit Preparation
1. Install the hazard button and display previously removed from the factory
radio panel.
2. Attach the four included panel clips to the radio panel. (Figure A)
Continue to kit assembly
White
plastic
clips
(Figure A)
95-7344
Double DIN radio provision
1. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Mount the radio to the DDIN brackets
using the screws supplied with the
White
radio. (Figure A)
plastic
clips
3. Mount the radio/bracket assembly
into the dash. (Figure B)
4. Snap the radio trim plate over
the radio/bracket assembly and
reassemble dash in reverse order of
disassembly. (Figure C)
(Figure A)
3
Kit Assembly
(Figure B)
(Figure C)