IMPLEMENTS COUPLING
The machine is equipped with a quick
implement connection. Before mounting
the implement, make sure that the P.T.O.
engagement lever is in idle position.
When connecting or disconnecting the
implements, it is necessary to pull the
knob upwards and turn it through 90°,
engage the implement in the connection
sleeve and bring the knob back to its
original position. Make sure that the
shutter has gone into the stop hole.
ROTARY HOE
Technical characteristics:
Rotary Hoe speed: 310 rev/min., with
engine at 3600 rev/min.
Hood width:50-40 cm and 60-65 cm.
N° blades: 16
Working depth adjustment
In order to vary the working depth, adjust
the central hoe's inclination by removing
fixing screw (2) and shifting the perfora-
ted rod (3) until it meets a new hole.
When working with hard terrain, to pre-
vent the machine from bounding forwar-
ds, adjust the central knife by moving it
downwards into the last hole.
MAINTENANCE
ATTENTION - Maintenance opera-
tions must be carried out with machi-
ne at standstill and engine switched
off.
Fig. 18A
Fig. 19A
Each time the Rotary Hoe is used che-
ck that:
1. The bolt is turned until it trips into grip-
ped position.
2. The the blades' nuts and fixing
screws are well tightened.
3. The oil of the bevel pair gear box is
at correct level, i.e. almost full.
ATTENTION - When changing the bla-
des ensure that they are fitted in the
same way.
Fig 20a
39