Kit Assembly - Metra 95-93078 Manual Del Usuario

ISO DDIN radio provision
1. Secure the ISO DDIN radio housing into the radio cavity
using the (4) factory screws removed in disassembly,
and the (2) #8 x 1/2" Phillips screws supplied with the
kit. (Figure A)
2. Secure the radio brackets to the radio using the (8) ISO
screws supplied with the kit. (Figure B)
3. Locate the factory wiring harness and antenna
connector in the dash and complete all necessary
connections to the radio. Metra recommends using
the proper mating adapter from Metra and/or AXXESS.
Reconnect the negative battery terminal and test the
radio for proper operation.
4. Slide the radio into the radio housing until it clicks in.
5. Attach the (4) panel clips supplied with the kit onto the
legs of the ISO DDIN radio trim plate. (Figure C)
6. Attach the ISO DDIN trim plate over the radio.
7. Reassemble the dash in the reverse order of
disassembly.
METRA. The World's best kits.
Installation instructions for part 95-9307B

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
™
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER