Residual Risks - DeWalt DCS310 Traducido De Las Instrucciones Originales

small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be
ejected from the battery, avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
6) SERVICE
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional Safety Instructions for
Reciprocating Saws
• Hold power tool by insulated gripping
surfaces when performing an operation
where the cutting accessory may contact
hidden wiring. Cutting accessory contacting a
"live" wire will make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
• ALWAYS wear a dust mask. Exposure to
dust particles can cause breathing difficulty and
possible injury.
• NEVER switch on the tool when the saw blade
is jammed in the workpiece or in contact with
the material.
• Keep hands away from moving parts. Never
place your hands near the cutting area.
• Use extra caution when cutting overhead
and pay particular attention to overhead
wires which may be hidden from view.
Anticipate the path of falling branches and
debris ahead of time.
• Do not operate this tool for long periods of
time. Vibration caused by the operating action
of this tool may cause permanent injury to
fingers, hands, and arms. Use gloves to provide
extra cushion, take frequent rest periods, and
limit daily time of use.
SWITCHING ON AND OFF
• After switching off, never attempt to stop the
saw blade with your fingers.
• Never put the saw down on a table or work
bench unless switched off. The saw blade will
keep running briefly after the tool has been
switched off.
WHEN SAWING
• When using saw blades specially designed for
cutting wood, remove all nails and metal objects
from the workpiece before starting work.
• Wherever possible, use clamps and vices to
fasten the workpiece securely.
• Do not attempt to saw extremely small
workpieces.
• Do not bend too far forward. Make sure
that you always stand firmly, particularly on
scaffolding and ladders.
• Always hold the saw with both hands.
• For cutting curves and pockets, use an adapted
saw blade.
CHECKING AND CHANGING THE SAW BLADE
• Only use saw blades conforming to the
specifications contained in these operating
instructions.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent saw
blades should be discarded and replaced at
once.
• Ensure that the saw blade is securely fixed.

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
EN GL IS H
35