Suntec Wellness Klimatronic Progress plus Manual De Instrucciones página 19

Press the "Temp +"or" Temp -" button to select a desired room temperature. (16°C-31°C)
-
Press the "Fan Speed" button to select wind speed.
-
After setting, the current room temperature is shown on the display.
-
3. Auto Mode
Press the "Mode" button till the "Auto" icon (see Figure 4) appears.
-
- Press the "Temp +"or" Temp -" button to select a desired room temperature.
- After setting, the room temperature is shown in the display.
- in Auto mode, the fan speed is changeable.
- Auto mode means, that the unit will turn off, when the desired room temperature is reached and it will turn on, if the room
temperature changes again.
- If the room temperature is equal to or above 18 ° C, the unit can cool in the automatic mode. At lower temperatures the device
will protect the compressor by automatically switching into ventilation mode.
5. Dehumidifying operation
Press the "Mode" button till the "Dehumidify Indicator Lamp" (see Figure 4) blinks
The unit will set the temperature and the fan speed by itself.
-
5. Timer operation
Timer ON setting cooling:
When the air-conditioner is OFF, press the "Timer" button and select a desired ON time through the temperature and time
-
setting buttons.
- ON time can be regulated at any time in 0-24 hours.
Press the "Timer" button to confirm your setting.
-
Timer OFF setting cooling:
When the air-conditioner ON, press "Timer" button and select a desired OFF time through the temperature and time
-
setting buttons.
OFF time can be regulated at any time in 0-24 hours.
-
Press the "Timer" button to confirm your setting.
-
Timer On setting dehumidifying:
- Choose the dehumidifying mode as described in 4.
When the air-conditioner OFF, press "Timer" button and select a desired ON time through the temperature and time setting
-
buttons.
- Time can be regulated at any time in 0-24 hours.
Press the "Timer" button to confirm your setting.
-
Timer OFF setting dehumidifying:
When the air-conditioner ON, press the "Timer" button and select a desired OFF time through the temperature and time
-
setting buttons.
OFF time can be regulated at any time in 0-24 hours.
-
Press the "Timer" button to confirm your setting.
-
6. Drainage
When you plan to leave this unit unused for a long time, please remove the rubber blockage from the drainage
-
hole at the bottom of unit, and connect a drain hose to the lower fixing clip. All the water in the water tank will
drain outside.
If water pump is damaged, continuous drainage can be used, and under this condition, the water pump is not
-
activated. The unit can also work well.
- If water pump is damaged, intermittent drainage can also be used. Under this condition, when the water full
indicator lamp lights up, please connect a drain hose to the lower fixing clip, then all the water in the water tank
19