Suntec Wellness Klimatronic SUMMIT plus Manual De Instrucciones página 25

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
drain method, refer to the "Drain"). If the unit is not shut down manually, the unit will be restored to the
previous operating status automatically once the water is fully drained. Or the power may be turned
on again to start the unit.
3.
Delay protection function of the compressor:
This unit offers restart protection for the compressor. Except that the compressor may start
immediately when the unit is energized for the first time, there is 3-minute delay start protection
after the compressor is shut down.
Emptying of the water tank
The unit has an automatic water evaporation system. Condensed water will be used to cool the
condenser. Thus the cooling performance will be increased and the energy will be saved.
As soon as the water tank is full, the "FL" blinks on the display, the standby mode automatically turns
on, it will sound the warning alarm and all the buttons will be locked until the tank is emptied.
To empty of the water tank you need to remove the rubber stopper on the bottom of the unit and let the
water leak into a container.
Turn off the power and unplug the power cord. Once you reboot the device, it will work normally.
water plug
drain cup
Cleaning
Before starting cleaning or maintenance, turn the power off by pressing the POWER button, wait a few minutes
and then unplug the power cord from the outlet.
Surface cleaning
Unplug the unit.
Clean the unit using a damp cloth, and then wipe it using a dry cloth. Do not use chemical solvents
(such as gasoline, alcohol).
Do not use the water for the cleaning of the unit
Air filter cleaning
Clean the air filter regularly (every 2 weeks). If the air filter is clogged with dust, the efficiency of the device
could be reduced.
Pull out the air filter frame and condenser filter frame in the direction as shown in figure 15. Now you can then
remove the air filter and condenser filter as shown on figure 16.
Wash the air filter by submersion into warm water (about 40° C) with neutral detergent, rinse it under running
water and dry it with a soft cloth.
Note: Please make sure not to damage frames during the cleaning,
gripping
position
gripping
position
water outlet
gripping
position
gripping
position
25

Publicidad

Tabla de contenido
loading

Tabla de contenido