Power Cord Connection; Connecting To The Input Connectors - Pioneer DJM-1000 Manual De Instrucciones

BEFORE USING (CONNECTIONS)
Before making or changing connections, switch off the power and disconnect the power cord from the AC outlet.

POWER CORD CONNECTION

Connect the power cord last.
÷ When all other connections are completed, connect the supplied power cord to the AC inlet located on the rear panel of this unit, and
connect the power plug to an AC outlet or auxiliary power socket on an amplifier.
÷ Be sure to use only the supplied power cord.

CONNECTING TO THE INPUT CONNECTORS

PIONEER DJ CD players
Connect the DJ CD player's audio output connectors to one of the
sets of CD/LINE input connectors on the DJM-1000, and connect
the control cable to the corresponding channel's CONTROL
connector. Switch the input selector switch of the connected
channel to [CD/LINE].
When using digital connections, connect the digital coaxial output
connector to one of the DIGITAL input connectors of the DJM-
1000, and switch the input selector switch of the connected
channel to [DIGITAL] (no digital input connectors are provided for
channel 1 and channel 2).
Analog turntables
Connect the audio output cables of the analog turntable to one set
of PHONO input connectors on the DJM-1000, and switch the input
selector switch of the connected channel to [PHONO]. The PHONO
input of the DJM-1000 supports MM cartridges.
The ground cable of an analog turntable is connected to one of the
SIGNAL GND terminals.
DJ CD player
2
HOT
POWER
OFF ON
L
MASTER 1
R
AC IN
fs(Hz)
48k
6
<DRB1372>
En
DJ CD player
R L R
OUTPUT
3
SIGNAL GND.
COLD MASTER ATT.
6
0dB
1
–3dB
GND
–6dB
PHONO CD / LINE PHONO CD / LINE
–12dB
MASTER 2 REC
L
L
R
R
L
BOOTH
(TRS)
SUBMIC SUBMIC
R
DIGITAL OUT
CONTROL DIGITAL CONTROL DIGITAL
96k
CD player, etc.
Other line level output devices
When connecting cassette decks or CD players, connect the audio
output connectors to one of the CD/LINE input connectors of the
DJM-1000, and switch the input selector switch of the connected
channel to [CD/LINE].
When the connection plug is a Ø6.3 mm phone plug, connect to
one of the LINE input connectors of the DJM-1000, and switch the
input selector switch of the connected channel to [LINE] (no LINE
input connectors are provided for channel 5 and channel 6). When
only the L channel is connected, the input in the L channel will be
input to the R channel as well.
Digital output devices
When using digital connections to devices such as CD players,
connect the device's digital coaxial output connector to one of the
DIGITAL input connectors of the DJM-1000, and switch the input
selector switch of the connected channel to [DIGITAL] (no DIGITAL
input connectors are provided for channel 1 and channel 2).
Analog turntable
L R
INPUT
SIGNAL GND.
5 4 3
PHONO CD / LINE PHONO CD / LINE PHONO
L L L
R R R
L L L
(MONO) (MONO) (MONO)
LINE LINE LINE
R R R
CONTROL DIGITAL CONTROL DIGITAL CONTROL SOUND 2
L R
R L
Analog turntable
L L R
SIGNAL GND.
2 1
2 SEND 1
CD / LINE PHONO CD / LINE
L L
R R
L
(MONO)
LINE
R
2 RETURN 1
EFX 2 EFX 1
CONTROL SOUND 1
Cassette deck, etc.
L
MIDI OUT
(MONO)
R
L
(MONO)
VISUAL
R