Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (G) and lay it over your unit.
Make equal margins along the short edges and along the long
å
edges of the BACK (G). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure the two large holes in the BACK line up over the
å
head of the screw in the LEGS and to tap NAILS into the holes
that line up over the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Page 14
This large hole must line
up over the SCREW head.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line
up over the UPRIGHTS.
G
413010
1N
NAIL
(36 used in this step)
This large hole must line
up over the SCREW head.
www.sauder.com/services
Publicidad
