Publicidad
Step 12
Fasten the HINGES (14H) to the DOORS (H and I). Use eight BLACK 1/2" FLAT HEAD SCREWS (11S).
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the diagram below. If
å
it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the RIGHT DOOR (H) to the RIGHT END (A). Use the screws in the HINGES. You should start each SCREW a few
å
turns before completely tightening any of them.
Fasten a PULL (6K) to the RIGHT DOOR (H). Use two BLACK 7/8" MACHINE SCREWS (37S).
å
Peel a FELT DISC from the FELT DISC CARD (1M) and stick it on the corner of the DOOR where it comes in contact with
å
the UPRIGHT (C).
Repeat this step for the other door.
å
See the next step for
å
DOOR adjustments.
14H
Page 16
I
H
14H
A
C
BLACK 7/8" MACHINE SCREW
(4 used for the PULLS)
413010
BLACK 1/2" FLAT HEAD SCREW
(8 used for the HINGES)
Stop
Mounting
screw
Hinge
1M
H
37S
www.sauder.com/services
11S
6K
1M
1M
Publicidad
