Publicidad
Idiomas disponibles
Idiomas disponibles
1.7.4. Back cover pipe back piece (C-5). Place the back piece of flue pipe (if
necessary should cut this piece to the height of the room).
1.7.5. Inner flue pipe. The fireplace is supplied with an inner tube section to
improve performance. This is attached to the smoke outlet neck with two screws
(C-6), once the placement of inner tube section, we place the vent pipe to the
outside of the house.
1.7.6. Frontal cover pipe piece (C-7). This piece if necessary, to be cut to the
height of the room. Front placement flue pipe has only one position: the notch
must fit the gas handle log located at the rear of the appliance.
1.7.7. Ceiling crest (C-8). First lay the back piece (which is the smallest) and then
the front piece, screwing both the ceiling with screws provided.
1.8. inner appliance (C-9). The vermiculite pieces are placed inside the
appliance, for easy transport and placement of the fireplace, these parts can be
removed to replace them, follow these steps:
1.8.1. Base pieces (C-10,C-11,C-12). First you place the outer core parts, starting
with the two sides and then the front pieces.
Place the inner pieces, starting with the two sides (C-13) and then the front part
(C-14).
1.8.2. Back pieces. First put the pieces of the lateral line (C-15), both the lower
and upper. Finally, place the two pieces of background plants (C-16).
1.8.3. Rear protective part (C-17). The rear protective plate is located above the
grate frame and subject to heat the tab.
1.8.4. Deflected panel (C-18,C-19). The deflected panel is located above the rear
protective plate and secured by the top with a metallic support.
1.9. Access for cleaning and security. From inside the mouth can make a
perfect cleaning of the chimney flue and removing the baffle plate, to remove only
have to release the bracket that holds it.
2. USER'S GUIDE
ALL LOCAL, NATIONAL AND EUROPEAN STANDARDS MUST BE COMPLIED
WITH WHEN INSTALLING THE APPLIANCE.
Warning: When in operation this appliance gets very hot, do not touch the
appliance without using the glove provided.
WARNING:
To respect the maximum load allowed by the manufacturer of the logs as
well as the height of recharge.
2.1. Using the appliance for the first time. For early on, and for a reasonable
time, the fuel load should not exceed 50% C.M.A. (Maximum fuel load authorised
by the manufacturer).
Página 23 de 36
Publicidad
