Publicidad
Idiomas disponibles
Idiomas disponibles
2.2. Combustion control.
2.2.1. Primary and secondary registers. Is located at the back left of the
fireplace (C-20) and is activated by pulling the lever out.
The second register is located at the back right of the fireplace (C-21) and is
operated in the same way: by pulling the lever out.
2.3. Check-out gas. It is located in the vent tube on the rear side of the fireplace.
To operate, operate the lever 90 ° clockwise or reverse to open or close the flow
of gases.
2.4. Register for double combustion (C-22, C-23). This fireplace has a register
that drives the double combustion gases. With the help of the tool, pull the log at
the back of the fireplace. To open it, push the lever in, to close, pull this lever out.
ATTENTION:
The positions indicated are according to technical characteristics table, in
any case these positions must be adapt according to the flue depression
and fuel quality.
2.4. Safety distances. Appliances, furniture and other flammable or fragile items
(textiles, electronics, wood, wallpaper, glass, paper, plaster, etc..) Should not
approach within 1300 mm of the side wall 400 mm rear and 1000 mm from the
front.
2.5. Type of combustion. This fireplace is intermittent combustion.
2.6. Authorised fuel by the manufacturer. Do not use the appliance as
incinerator, and only use fuels approved by the manufacturer. Use natural logs
that have a moisture content between 12 and 20 %. It is highly recommended to
dry newly cut wood for 2 years. Their maximum length must not be longer than
450 mm. The use of other types of fuel is forbidden, as well as any liquid (used to
light barbecue fires).
2.7. Loading and reload fuel. Do not exceeded the maximum authorized load of
fuel (see table of technical characteristics); ensure that when refuelling the fuel
does not exceed 175 mm in height. A log guard is provided. Do not allow the fuel
above the log guard.
IMPORTANT NOTE:
Interior parts vermiculite SHOULD NOT BE HIT, especially when done
refueling.
If any of these parts are cracked, but is properly placed in your site, does
not alter the proper functioning of A POTENTIAL RISK. The device can be
used normally.
These cracks do not pose any manufacturing defects so you do not fall under
warranty.
To light the fire using materials suitable for this purpose, such as heat pads, gel
on, paper or thin dry branches. DO NOT USE GASOLINE, SOLVENTS OR
Página 24 de 36
Publicidad
