Fitting The Door Panels - Electrolux FI5004NA+ Manual De Instrucciones

16 www.electrolux.com
• 1. Rear edge
• 2. Front edge
• 3. Right hand side panel
The dimension of 260* mm is allowed
for fitting a 100 mm plinth below the
panel. For different plinth sizes,
increase the dimension of 260* mm
accordingly.
2. Apply spacers to the hinges before
installing the appliance into the
cabinet . See picture
2
3. Rest the panels against the
appliance.
4. Fit the rear brackets, taking into
account the thickness of the panels
(maximum width of unit 900 mm).
For a correct alignment make sure
that the distance between the
appliance and the cabinet is of 45
mm.
5. Secure the panels at the front.
D
1
6. Fix the squares (contained in the
bag) to the lower part of the door
(references already provided).
7. If necessary, door opening angle
max 90° can be obtained by
introducing the pivots supplied
separately. See picture.
D
L

8.5 Fitting the door panels

1. Open a door a remove the bracket
cover. Undo the nuts with washers
and remove the bracket from the
door.
45 mm
2. Drill the small doors as shown in the
figure.
L
o
90
o
115
2
1
10 mm
N
N