Switching The Appliance Off Early; Overheating Cutout; Cleaning And Storing; Cleaning The Base - NUK Thermo Ultra Rapid Manual Del Usuario

6.3 Switching the appliance off
early
The device can only be switched off prematurely
by pulling out the plug.
G
B
Warning! To avoid the risk of electric
shock, injury or damage:
– take the plug out of the socket before
cleaning the appliance.
– allow the appliance to cool down
before cleaning it.
– never immerse base 3 in water.
Caution! Under no circumstances use abrasive,
corrosive or scratching cleaning agents, as
these could damage the appliance.

7.1 Cleaning the base

1. Clean base 3 using a damp cloth. You can
also use a little detergent.
2. Wipe over with clean water.
3. The inner base 3 should be wiped out with a
cloth after each use to prevent significant
limescale build-up.
4. Only use the appliance again when it is
completely dry.

6.4 Overheating cutout

The appliance also has an overheating cutout to
rule out the risk of fire in the event of
overheating. If it trips, this device can only be
replaced by a specialist or by the manufacturer.
Contact the relevant service address (see
"Contact addresses" on page 108) for this
purpose.

7. Cleaning and storing

7.2 Cleaning the accessories

1. Clean measuring container 4, basket 9,
2. Do not use the accessories again until they
7.3 Descaling
After a period of use, limescale will build up in
the appliance (depending on the hardness of the
mains water where the appliance is being used).
You should remove this limescale at regular
intervals to guarantee the function of the
appliance. Limescale can cause performance to
deteriorate considerably.
Caution! Do not use commercially available
descalers, pure acetic acid or vinegar essence.
1. To get rid of limescale, we recommend
Note: Longer periods will not improve descaling
but may damage the appliance in the long term.
26
trivet 10 and ring 8 by hand in the sink or in a
dishwasher.
are completely dry.
pouring 100 ml of white vinegar and 100 ml
of boiling water into the appliance and
leaving it to take effect for 30 min.