Optional Accessories - DeWalt DCH213 Traducido De Las Instrucciones Originales

EN GLI SH
– Replace the tool holder with the chuck
(DCH214).
3. Proceed as described for rotary hammering.
CAUTION: Never use standard chucks
in the rotary hammering mode.
SCREWDRIVING (FIG. 1)
1. Set the mode selector switch (c) to the "rotary
drilling" position.
2. Select the direction of rotation.
3. Depending on your tool, follow either of the
following instructions:
– Insert the special SDS Plus
adaptor for use with hexagonal screwdriver
bits (DCH213).
– Replace the tool holder with the chuck
(DCH214).
4. Insert the appropriate screwdriver bit. When
driving slotted head screws always use bits with
a finder sleeve.
5. Gently press the variable speed switch (a) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
6. When the screw is flush with the workpiece,
release the variable speed switch to prevent
the screw head from penetrating into the
workpiece.
CHIPPING (FIG. 1)
1. Set the mode selector switch (c) to the
"hammering only" position.
2. Insert the appropriate chisel and check if it is
properly locked.
3 Adjust the side handle (e) as required.
4. Switch on the tool and start working.
It may be necessary to briefly run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
42
This machine is not user-serviceable. Take the
tool to an authorised D
approximately 40 hours of use. If problems occur
before this time contact an authorised D
repair agent.
The charger and battery pack are not serviceable.
®
screwdriving
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
CHARGER CLEANING INSTRUCTIONS

Optional Accessories

WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
WALT repair agent after
E
WALT
E
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
WARNING: Since accessories, other
than those offered by D WALT, have
E
not been tested with this product, use
of such accessories with this tool could