Overload Clutch - DeWalt DCH213 Traducido De Las Instrucciones Originales

internal active vibration control. Applying too much
pressure will not make the tool drill faster and active
vibration control will not engage.
SDS Chuck (fi g. 5)
To insert bit, insert shank of bit about 19 mm (3/4")
into chuck (l). Push and rotate bit until it locks in
place. The bit will be securely held.
To release bit, pull the sleeve (m) back and remove
the bit.
Replacing the Tool Holder with the
Chuck (fi g. 7)
DCH214
1. Turn the locking collar (o) into the unlocking
position and pull the tool holder (n) off.
2. Push the chuck (p) onto the spindle and turn
the locking collar into the locking position.
3. To replace the chuck with the tool holder, first
remove the chuck the same way as the tool
holder was removed. Then place the tool holder
the same way as the chuck was placed.
WARNING: Never use standard chucks
in the rotary hammering mode.

Overload Clutch

In case of jamming of a drill bit, the drive to the
drill spindle is interrupted. Because of the resulting
forces, always hold the tool with both hands and
take a firm stance.
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework
and wiring.
• Apply only a gentle pressure to
the tool (approx. 5 kg). Excessive
force does not speed up drilling but
decreases tool performance and may
shorten tool life.
• Do not drill or drive too deep to
prevent damage to the dust cover.
• Always hold the tool firmly with both
hands and ensure a secure stance.
Always operate the tool with the side
handle properly mounted.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
Proper Hand Position (fi g. 1, 6)
WARNING: To reduce the risk of
serious personal injury, ALWAYS
use proper hand position as shown
in figure 6.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle (h), with the other hand on the side handle
(e).
Drill Operation (fi g. 1)
WARNING: To reduce the risk of
serious personal injury, turn tool off and
disconnect tool from power source
before making any adjustments or
removing/installing attachments or
accessories.
WARNING: To reduce the risk of
personal injury, ALWAYS ensure
workpiece is anchored or clamped
firmly. If drilling thin material, use a wood
"back-up" block to prevent damage to
the material.
HAMMERDRILLING (FIG. 1)
1. Set the mode selector switch (c) to the "rotary
hammering" position.
2. Insert the appropriate drill bit. For best results
use high quality carbide-tipped bits.
3. Adjust the side handle (e) as required.
4. Mark the spot where the hole is to be drilled.
5. Place the drill bit on the spot and switch on the
tool.
ROTARY DRILLING (FIG. 1)
1. Set the mode selector switch (c) to the "rotary
drilling" position.
2. Depending on your tool, follow either of the
following instructions:
- Fit a chuck adaptor/chuck assembly
(DCH213). Special SDS Plus adaptors with
threaded sections are available for use with
standard 10 or 13 mm chucks to enable
straight shank bits to be used.
EN GL IS H
41