Maintenance Instructions - Desoutter ESP2-A Manual Del Usuario

6159922220_05
E2 No Pset selected
when tool A enabled.
The Pset selected
by the controller and
the PLC is not the
same.
E3 Screwdriver short-
circuit or overload.
E4 Over temperature
E5 Motor thermal
protection
E7 Activation of the
screwdriver Fwd/
Rev Switch during
tightening or reverse
phase
E8 Brake before start,
tool can't start,
Controller generate
NOK signal
E9 Controller memory
error
EA Communication
error with the tool
NS The tool does not
shut-off before max.
time.

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task:
- Disconnect the tool.
- Check that the controller is switched off.
- Disconnect the cable.
Fuse
The fuse is to be changed by qualified service
personnel only.
● Always replace with a fuse of the same
reference.
Check the
configurations.
Select the same
Pset for the
controller and the
PLC.
Check the tool
connections.
Wait until the
temperature is
correct.
Wait 10 seconds
before starting the
tool.
Selected Fwd/Rev
position of the
screwdriver Fwd/
Rev Switch.
Check the joint.
Press the "Reset"
button on the front
panel.
Contact your
local Desoutter
representative for
support.
Check the tool
cable and the
connector.
Check the tool
is not triggered
before tightening
the part.
Adjust the
maximum time.
16 / 172
Assembly and disassembly
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
Meaning of the pictograms
Left hand thread.
When reassembling, apply the
recommended glue.
When reassembling, tighten to the
required torque.
When reassembling, lubricate with the
required grease or oil.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
English
02/2018