Technical Specifications - Black and Decker BXAE00021 Manual Del Usuario

Charging current for batteries: from 2Ah to 30Ah.
Maintenance mode for batteries: from 2Ah to 70Ah.
5.
Output lead: Cable with clamps 30A - Ref: BXAE00025.
6. Output lead: Cable with rings 6mm and protective, insulating, watertight cap.

2.1. Technical specifications

Reference
Model
Voltage (Mains)
Charging voltage
Charging current
Battery size
Operating temperature
Storage temperature
IP indication
Minimum battery voltage
2.2. Battery types
This electronic battery charger is designed to charge all types of lead batteries,
conventional batteries and batteries of the latest generation. This battery charger is ideal
for both everyday use, as a key working tool, and extensive charging cycles.
2.3. Charge cycles
The charge cycles of the battery charger have been specially developed to optimize the
charge of all types of batteries currently available in the market.
2.4. Safety devices
The battery charger is equipped with safety devices to ensure the utmost safety during
use and operation.
 Full protection against sparks
 Protection against short-circuits
 Protection against overheating
 Protection against polarity reversal
2.5. Battery tests and error indications
If the charge LED is OFF (not lightening); the following raisons/faults are possible:
CAUSE
The clamps/rings of the output lead are not
connected correctly to the battery.
Polarity reversal.
Leads disconnected, leads short-circuited.
Battery completely short-circuited.
Battery flat.
4
BXAE00021
Charger 6/12V-1.5A
220~240V AC 50/60Hz
6V / 12V
1.5A
2Ah to 70Ah batteries
-10° to +40°C
-20° to +50°C
IP20
3V
SOLUTION
Position the clamps/rings correctly and
start charging the battery again.
The battery may be defective. Contact a
battery service center.