Revell Control Moovee Manual De Instrucciones página 8

1. STArTiNg PrePArATioNS:
The actuating regulator (the left-hand
regulator on the remote control unit)
must point downwards before switching
on. Then set the remote control unit
control switch to "ON" (Fig. 1); then
the power LED will light up red. Select
channels A, B or C via the channel
selection switch.
2. TriMMiNg THe coNTroLS:
Correct trimming is the basic prerequisite for correct helicopter flight characteristics. It is easy to align the helicopter, but requires patience and sensitivity.
Please observe the following guidelines precisely: Move the actuating regulator carefully upwards to make the helicopter move approximately 0.5 to 1 metre upwards.
if the helicopter turns quickly or slowly to
the right by itself ...
If the helicopter turns quickly or slowly to the right by itself, briefly and repeatedly tap the
buttons for the contradirectional trim to the left until the helicopter no longer turns by itself.
Never just press the trim buttons continuously.
3. FLigHT coNTroLS:
In order to start or to fly the helicopter higher, push the actuating regulator
carefully forward.
In order to fly forwards, move the direction regulator carefully forwards.
In order to bank to the left, move the direction regulator carefully to the left if
the helicopter is flying with its tail facing the pilot.
4. ADDiTioNAL FLigHT FuNcTioNS:
8 8
Turbo button Demo button
Flying the helicopter
Fig. 1
Turbo button: Press this button for even more speed in
forwards and reverse flight!
caution: Do not steer excessively tight bends at high speeds.
The helicopter can become unsteady.
Note: This function is deactivated while recording a video.
Demo button:
You only need the control the thrust controller and your
helicopter will give you a demonstration. Caution! Make sure
you have sufficient space. You can stop the demo flight at any
time by moving the direction controller.
Now switch the
ON/OFF switch
on the side of the
helicopter to "ON".
The LED on the back
of the helicopter
starts to flash.
if the helicopter turns quickly or slowly to
the left by itself ...
If the helicopter turns quickly or slowly to the left by itself, briefly and repeatedly tap the
buttons for the contradirectional trim to the right until the helicopter no longer turns by itself.
Never just press the trim buttons continuously.
In order to land or to fly lower, move the actuating regulator backwards. Minimal
corrections to the regulator are required to allow the helicopter to fly smoothly.
In order to fly backwards, move the direction regulator carefully backwards.
In order to bank to the right, move the direction regulator carefully to the right if
the helicopter is flying with its tail facing the pilot.
Light button
Light button:
You switch the lighting on the helicopter on and off
with this button.
Place the helicopter
on the ground so
that the fuselage
points in your
direction. As soon
as initialisation of the gyros has
finished, the LEDs on the side of
the helicopter illuminate.