Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Avoiding Mould And Unpleasant Odours - Indesit TAN 2 Manual De Instrucciones

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
It is not sufficient to set the temperature adjustment
knobs on (appliance off) to eliminate all electrical
contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber
seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
• The removable accessories may be soaked in warm
water and soap or dishwashing liquid. Rinse and dry
them carefully.
• The back of the appliance may collect dust which can
be removed by delicately using the hose of a vacuum
cleaner set on medium power. The appliance must be
switched off and the plug must be pulled out before
cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic
materials which are odour free. In order to maintain an
odour free refrigerator and to prevent the formation of
stains, food must always be covered or sealed
properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors
open.

Defrosting the appliance

! Follow the instructions below.
Para descongelar el aparato no utilice objetos cortantes
o con punta porque podrían dañar irremediablemente el
circuito refrigerante.
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com
Defrosting the refrigerator compartment
hole regularly so that the water can flow out easily.
Defrosting the freezer compartment
If the frost layer is greater than 5 mm, it is necessary to
defrost manually:
1. Set the TEMPERATURE ADJUSTMENT knob to the
2. Wrap frozen foods in newspaper and place them in
3. Leave the door open until the frost has melted
4. Clean and dry the freezer compartment carefully
5. Wait for approximately 2 hours, i.e. until the ideal

Replacing the light bulb

To replace the light bulb in the refrigerator compartment,
pull out the plug from the electrical socket. Follow the
instructions below.
position .
another freezer or in a cool place.
completely. This can be made easier by placing
containers with lukewarm water in the freezer
compartment.
before switching the appliance on again.
storage conditions have been restored, before placing
food in the freezer compartment
1
2
The refrigerator has an
automatic defrosting
function: water is ducted
to the back of the
appliance by a special
discharge outlet (see
diagram) where the heat
produced by the
compressor causes it to
evaporate. It is necessary
to clean the discharge
Access the light bulb by
removing the cover as
indicated in the diagram.
Replace it with a similar
light bulb within the power
range indicated on the
cover (15W or 25W).
13
GB