Kit Preparation; Kit Assembly - Metra 99-7344G Instrucciones De Instalación

Kit Preparation

1. Install the hazard button and display previously removed from the factory
radio panel.
2. Attach the (4) included panel clips to the radio panel. (Figure A)
Continue to kit assembly
White
plastic
clips
(Figure A)
99-7344
ISO DIN radio provision with pocket
1. Secure the pocket to the radio
brackets using the (4) Phillips screws
provided.
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Secure the radio to the bracket/
pocket assembly using the screws
White
supplied with the radio.
plastic
clips
4. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
and/or AXXESS. Test the radio for
proper operation.
5. Secure the completed assembly into
the dash. (Figure A)
6. Connect all connectors to the display
and hazard, snap the radio trim plate
over the completed assembly, and
then reassemble the dash in reverse
order of disassembly. (Figure B)
3

Kit Assembly

(Figure A)
(Figure B)