Kit Preparation - Metra 99-6526 Instrucciones De Instalación

1. Cut and remove the shaded area
from the radio cavity. (Figure A)
From the factory radio trim panel:
2. Remove the retaining clips, and
then attach them onto the radio
trim panel.
3. Remove the (4) Torx T-15 screws
securing the hazard switch panel,
and then remove the panel.
(Figure B)
4. Secure the hazard switch panel to
the radio trim panel using the (4)
#8 x 3/8" Phillips screws provided.
(Figure C)
5. Clip the factory A/C vents removed
in dash disassembly into the radio
trim panel. (Figure C)
Continue to Kit Assembly

Kit Preparation

Remove shaded area
(Figure A)
(Figure B)
99-6526
(Figure C)
4