Kit Preparation; Kit Assembly - Metra 99-8235 Instrucciones De Instalación

Kit Preparation

1. Attach the clock/hazard switch
bracket to the radio housing using
the (6) #4 x 3/8" Phillips pan head
screws. (Figure A)
WARNING: DO NOT OVERTIGHTEN
SCREWS.
2. Clip the clock/hazard switch
assembly into the 95-8235 radio
housing trim panel.
(Figure B)
3. Install the three included panel
clips to the back of the radio
housing trim panel (factory clips
can also be used if desired).
Continue to kit assembly
Insert Clock/Hazard switch assembly from
rear of 99-8235 radio housing trim panel
(Figure A)
(Figure B)
99-8235
ISO DIN head unit provision
with pocket
1. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Slide the radio into the bracket/
pocket assembly and secure with
screws supplied with the radio.
(Figure B)
3. Secure the radio/pocket assembly
into the sub dash using the
factory hardware.
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble dash in reverse
order of disassembly using the
99-8235 radio trim panel instead
of the factory panel.
3

Kit Assembly

(Figure A)
(Figure B)