Kit Preparation - Metra 99-5839CH Instrucciones De Instalación

1. There are two different radio/display
sub-trim panels to choose from. One for
mounting the radio in the upper portion
of the kit, and another one for mounting
it in the lower portion. (Figure A)
If mounting the radio in the upper
portion, a factory module will need to
be re-located:
a. Remove the module from the sub-
dash and relocate it to the bottom
of the dash opening. The mounting
brackets attached to the module will
need to be bent outward to make
room for the radio.

KIT PREPARATION

(Figure A)
(Figure B)
2. Attach the desired radio/display sub-
trim panel to the radio/display panel
using the (12) #6 x 3/8" pan-head
screws provided. (Figure B)
3. Attach the touchscreen display
assembly to the radio/display sub-panel
using the (4) #8 x 3/8" truss-head
screws provided. (Figure C)
4. Attach the (4) panel clips provided to
the radio/display panel. (Figure D)
Continue to Kit Assembly
(Figure C)
(Figure D)
REV. 8/2/2017 INST99-5839CH
3