Clip Connection; Filter Dedusting - Kärcher NT 611 Eco K Manual De Instrucciones

Remove the paper filter bag/fleece filter bag
Illustration
 Release and remove the suction head.
 Pull the paper filter bag/fleece filter bag towards the
rear.
 Insert and lock the suction head.
– To vacuum wet dirt, first remove the paper or fleece
filter bag.
Remove the membrane filter
Illustration
 Release and remove the suction head.
 Remove the membrane filter.
 Insert and lock the suction head.
– To suck wet dirt, always remove the membrane fil-
ter.
Coarse dirt filter installation
 Open filter door.
 Take out the flat folded filter.
 Install the coarse dirt filter.
 Close the filter door, it must lock into place.
Connection of disposal pump
Illustration
 Remove the cap.
 Connect the disposal hose (nominal width 3/4" or
larger).
Drain off dirt water
CAUTION
Please observe the local provisions regarding the
wastewater treatment.
Illustration
 Drain off dirty water through the drainage hose.
General
ATTENTION
The coarse dirt filter must never be removed during vac-
uuming.
– Wet vacuuming without disposal pump: It is recom-
mended to use a special filter bag (wet) (see Filter
systems).
– If the maximum liquid level is reached the appli-
ance will turn off automatically.
– After the wet vacuuming: Clean the floater, contain-
er and the disposal pump if necessary, using a
damp rag and dry them.
Dry vacuum cleaning
ATTENTION
Prior to dry vacuuming: Remove the disposal pump and
install the flat fold filter.
Note: You must use a flat fold filter during dry vacuum-
ing.
General
ATTENTION
The flat pleated filter must always be in place while vac-
uuming.
– To vacuum fine dust, you can also use an addition-
al paper filter bag, a fleece filter bag or a membrane
filter.
Removal of the disposal pump
 Unplug the mains plug of the disposal pump.
 Release and remove the suction head.
Illustration
 Unscrew the acorn nut of the disposal pump.
12
 Remove the cable holder of the disposal pump and
replace it with a locking cap.
 Remove the disposal pump and plastic insert si-
multaneously from the container as the float switch
of the disposal pump is attached to the plastic in-
sert and could otherwise be damaged.
Illustration
 Install the locking cap instead of the disposal hose.
 Insert and lock the suction head.
Installation of flat fold filter
Note: The flat fold filter is not included in the delivery.
 Open filter door.
 Take out the coarse dirt filter.
 Install the flat fold filter.
 Close the filter door, it must lock into place.
Install the brush strip
Illustration
 Remove the rubber lips.
 Install the brush strip.
Installing the paper filter bag/fleece filter bag
Note: A paper filter bag or a fleece filter bag is not in-
cluded in the delivery.
Illustration
 Release and remove the suction head.
 Place the paper or fleece filter bag.
 Insert and lock the suction head.
Install membrane filter
Note: A membrane filter is not included in the delivery.
Note: If you work without the paper filter bag or fleece
filter bag, you must use a membrane filter to protect the
suction head.
Illustration
 Release and remove the suction head.
 Pull the membrane filter over the container edge.
 Insert and lock the suction head.
Illustration
The suction hose is equipped with a clip system. All C-
40/C-DN-40 accessories can be connected.
DANGER
Risk of injury and damage! The socket outlet is intended
only for the direct connection of the disposal pump. Any
other use of the socket outlet is not permitted.
Turning on the Appliance
 Plug in the mains plug of the appliance.
 Switch on the appliance at the main switch.
 Continuously dispose of large volumes of liquid:
Switch on the disposal pump.
Disposal or cleaning operation
 Continuously dispose of liquids or clean.
While vacuuming, clean the flat-fold filter at regular in-
tervals.
 Pull the handle of the filter clean-off out several
times and reinsert it.
– 2
EN

Clip connection

Operation

Filter dedusting