Clip Connection; Operation; Storing The Appliance; Transport - Kärcher NT 65/2 Ap Manual Del Usuario

Emptying the container fully
 NT 75/2 Ap Me Tc only:
Illustration
 Lock parking brake.
 Hold the container at the handle and tilt
it by raising it.
 Empty the container fully.
 Fold the container back into its original
position.
 Release parking brake.
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if mostly wa-
ter is suctioned from a container it is
recommended not to activate the "man-
ual filter dedusting" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.

Clip connection

Illustration
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
14
Turning on the Appliance
 Plug in the main plug.
 Switch on the appliance at the main
switch.
Semi-automatic filter dedusting
Note: A filter dedusting every 5 to 10 min-
utes will increase the life of the flat folded
filter.
Note: The semi-automatic filter dedusting
function can only be switched on when the
appliance is switched on.
 Press the semi-automatic filter dedust-
ing key five times. The flat folded filter is
automatically cleaned through an air jet
(pulsating sound).
Turn off the appliance
 Press the semi-automatic filter dedust-
ing key five times.
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.

Storing the Appliance

Illustration
 Store the suction hose and the mains
cable as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
– 3
EN

Operation

Transport