Fitting & Operation Information - Cosatto nitty gritty port Berlin Manual Del Usuario

Fitting & Operation Information:
Please refer to the following diagrams:
Location 1-
Fitting 2-
Harness 3-
4-
5-
6-
Headrest 7-
IMPORTANT: Never use the child car seat on a seat
where an airbag is fitted and active. Refer to your
vehicle user manual for information on de-activating
the airbag.
WARNING: Your child car seat can only be
installed rearward facing using a three point lap and
diagonal vehicle belt in the front or rear passenger
seats of the car.
Adjust the handle to carrying
Position the child car seat on the vehicle seat, pass the vehicle
waist belt through the side vehicle belt guides (2) and fasten the
vehicle belt buckle (3).
Route the diagonal belt under handle hinge (4) then through rear
vehicle seat belt guide (5).
Tension the vehicle diagonal belt (6).
IMPORTANT: The position of the vehicle belt buckle
can affect the stability of the child car seat. In an
accident this could stop the child car seat from
protecting your child as well as it should. After
tightening the vehicle belt, if the buckle lies in the
position marked
another seating position in your vehicle. If in doubt
consult either the child car seat manufacturer or
retailer.
Loosening:
NOTE: Pull only the harness straps.
Tightening:
NOTE: The harness must be reasonably tight. It should restrain
but not make the child uncomfortable. Check that the straps are
not twisted while the child is seated.
Opening:
Closing:
Adjusting:
Loosen the harness 3 .
Pull the bottom section (1) of the adjustor and adjust the
headrest position (2).
position 8
then try fitting the child car seat in
9 (1).