Fitting & Operation Information - Cosatto HOLD Manual De Instrucciones

Fitting & Operation Information:
Please refer to the following diagrams:
Location 1-
Fitting 2-
Harness 3-
4-
5-
6-
7-
8-
9-
10-
IMPORTANT: Never use the child car seat on a seat
where an airbag is fitted and active. Refer to your
vehicle user manual for information on de-activating
the airbag.
WARNING: Your child car seat can only be installed
rearward facing using a three point lap and diagonal
vehicle belt in the front or rear passenger seats of the
car.
Adjust the handle to carrying position 11 12 (1).
Position the child car seat on the vehicle seat, pass the vehicle waist
belt through the side vehicle belt guides (2) and fasten the vehicle belt
buckle(3).
Route the diagonal belt under handle hinge (4) then through rear
vehicle seat belt guide (5).
Tension the diagonal belt (6).
IMPORTANT: The position of the vehicle belt buckle
can affect the stability of the child car seat. In an
accident this could stop the child car seat from
protecting your child as well as it should. After
tightening the vehicle belt, if the buckle lies in the
position marked
another seating position in your vehicle. If in doubt
consult either the child car seat manufacturer or retailer.
Loosening:
NOTE: Pull only the harness straps.
Tightening:
NOTE: The harness must be reasonably tight. It should restrain but not
make the child uncomfortable. Check that the straps are not twisted
while the child is seated.
Opening:
Closing:
Adjusting the shoulder strap position:
Loosen harness 3 (1).
Disconnect the shoulder straps from the harness connector (2).
Pull shoulder strap out of seat (1) and refit at desired position (2).
Reconnect the shoulder straps to the harness connector (3).
Tighten harness 4
Satisfactory shoulder strap position:
Check satisfactory chest pad position.
Crotch strap position adjustment:
Disconnect crotch strap clip from under seat (1).
then try fitting the child car seat in