Sigma EF-630 Manual Del Usuario página 28

1 TIME
Test flash
Executes a single test flash.
(Default)
Modeling flash
When the TEST button is kept pressed,
MODELING
continuous flashing of approximately 1.5
seconds is conducted so the subject's
shadows can be checked.
CUSTOM MODE (MENU 3)
It is possible to store and recall
custom settings. (Two series of
custom settings can be stored.)
STORING AND RECALLING
CUSTOM SETTINGS
1. Set the Flash mode, Mode details area, and Setup menu
contents as desired.
2. From [MENU 3] → [CUSTOM MODE SETTING], select [C1]
or [C2] and press the
3. Select [OK] and confirm with the
The registered contents are added to the Flash mode as the
Custom mode. (The Custom mode is indicated with the
or mark in the Flash mode area.)
DELETING THE REGISTERED CUSTOM MODE
1. From [MENU 3] → [CUSTOM MODE DELETE], select [C1]
or [C2] and press the
28
button.
button.
button.
2. Select [OK] and confirm with the
AF ASSIST LIGHT (MENU 4)
The AF assist light will turn on automatically as you focus on a
subject in a dark area. The effective range of the AF assist light
is from about 0.7 to 10 meters (2.3-29.5 feet).
 When the AF assist light is not necessary, set [MENU 4] →
[AF ASSIST LIGHT] → [OFF].
LCD PANEL LIGHT (MENU 4)
When the power supply is turned to ON, the LCD panel lights
up. The ON/OFF settings of the light can be changed.
[MENU 4] → [LCD LIGHT]
After 8 seconds of non-operation, the light will
AUTO
turn off. When a button or dial is used while the
(Default)
light is off, the light will automatically turn on.
Regardless of whether a button or dial is being
8 SEC pressed, the light will turn off after 8 seconds
from when the light initially turned on.
ON The light is kept ON continuously.
 Regardless of the setting, the light can be turned on/off with
the button.
LCD PANEL ADJUSTMENT (MENU 4)
The contrast and brightness of the LCD panel can be adjusted.
[MENU 4] → [DISPLAY SETTING]
button.