Keep Updated For Future Devices; Learning Commands - Philips SRU5106/27 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Example of DVD.
1
Set up the remote control for a device (in this example DVD)
as described in chapter 3.2.1 'Code search by brand'.
2
Select DVD by pressing the DVD mode button for more than 1
second.
The remote control sends out the 'Select DVD' command.
3
Press and immediately release the SETUP button. Then press
and immediately release the DVD mode button to select DVR.
The remote control sends out the 'Select DVR' command.
Notes
This method can be applied similarly to all Combo devices
(TV / DVR, TV / VCR, DVD / DVR, etc.) and is available for
all device modes.
Note that this feature is not supported by all codes.
5
Keep updated for future
devices

5.1 Learning commands

The learning feature allows you to 'learn' the remote control
functions from your original remote control.
For example: you may want to use your remote control to operate
the RANDOM PLAY feature from your original CD remote
control.
1
Press and hold the SETUP button until the red light indicator
turns on, then release the button.
2
Press and release the desired mode button (TV, DVR, etc.).
The red light indicator flashes, then remains lit.
3
Press and release the LEARN button.
The red light indicator flashes, then remains lit.
4
Press and release the button on the SRU5106 that you wish
to learn a new function (e.g. POWER).
5
Point both remote controls facing each other by
approximately 1 inch apart (refer to chapter 5.4 'Tips on
learning').
6
Press and hold the button from which you wish to learn on
the original remote control (e.g. POWER) until the red light
indicator flashes once and then remains lit.
If there is a learning problem, the red light indicator flashes
for three seconds and then remains lit. If this happens,
repeat steps 4 to 6.
7
Repeat steps 4 to 6 for other buttons you wish to learn a new
function.
8
Press and release the SETUP button when all desired remote
control commands have been learned.
Code Learning is now complete.
10
EN
± 1 inch

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido