Using The Remote Control; Controlling Devices Requiring Separate Power On / Off Buttons; Controlling Combo Devices - Philips SRU5106/27 Instrucciones De Manejo

You can change which Volume / Mute buttons are used for a
device (e.g. use the Volume buttons of the amplifier to control the
volume of the DVD player).
3.4.1 Setting Volume / Mute control for all
devices to any single device
You can set all devices to use the Volume / Mute buttons of a
single device without needing to change to that device mode.
1
Press and hold the SETUP button until the red light indicator
turns on, then release the button.
2
Press and hold the MUTE button until the red light indicator
flashes off, then release the button.
3
Press and release the desired device Mode button (TV, DVR,
etc.) for Volume / Mute control, the red light indicator flashes
then remains lit.
4
Press and release the MUTE button.
• The red light indicator turns off.
• The red light indicator will blink rapidly for three seconds
if the device you have selected has no Volume / Mute
control.
• All other devices will now use the Volume / Mute buttons
of the selected device.
5
Press and release the MUTE button.
• The red light indicator turns off.
• The selected device will now use its own Volume / Mute
control.
4

Using the remote control

4.1 Controlling devices requiring separate
Power On / Off buttons
Some devices (e.g. certain RCA TVs) require separate Power On
and Power Off buttons to turn the device on and off.
The equivalent button functions can be found on your Philips
remote control.
1
Turn on the device by pressing the corresponding Mode
button for more than 1 second.
2
Press and release the POWER (
device.
Notes
• This method can be applied similarly to any device and is
available for all device modes.
• Note that this feature is not supported by all codes.

4.2 Controlling combo devices

Some combo devices (e.g. TV / DVR, TV / DVD, DVD / DVR, etc.)
have separate buttons on the original remote control to select
the part of the combo device to be controlled.
For example, if your combo device is a TV / DVD then its original
remote control might have separate TV and DVD buttons for
selection of the combo part you wish to operate. The equivalent
button functions can be found on your Philips remote control by
using the device Mode and SETUP buttons.
) button to turn off the
y
EN 9