Ecco 12+ Pro Vantage Serie Manual Del Usuario página 3

Gutter Mounting
IMPORTANT! Mounting brackets are specific to the vehicle model. Please make sure the brackets are suitable for the vehicle before
installation. Install on the structural part of the roof that has the least amount of flex.
1. Remove mounting foot. Position bracket onto nubs of the foot.
2. Holding the bracket and foot together, insert the cage nut as shown. It will fit snugly underneath the mounting foot. Do not install it on
the outside face.
3. Install the mounting feet in reverse order of their removal. The metal bracket will be sandwiched between the bar and the composite
mounting foot. Adjust the spacing of the mounting feet before securely tightening the nuts.
4. Hand thread the M6 bolt through the star washer and mounting strap into the cage nut. Be careful not to cross thread the bolt, and
leave loose until later steps.
5. Once the bar is in position, use the strap as a template to drill Ø1/8" holes. It may be necessary to pull back the door sealing gasket or
trim. Apply silicone or sealant around the hole, behind the strap. Secure the straps with the provided #10 stainless steel sheet metal
screws with washers as shown. Screws should be tightened around 5-10 in-lb.
6. Tighten the M6 bolts evenly so that the bar is even and centered. Reinstall any removed trim and/or weather-stripping and close doors
to check secure fit of the lightbar.
M6 SCREW M6 SCREW
MOUNTING MOUNTING
STRAP
STRAP
#10 STAR WASHERS #10 STAR WASHERS
SHEET METAL SCREWS
SHEET METAL SCREWS
LIGHTBAR
LIGHTBAR
MOUNTING FOOT MOUNTING FOOT
M6 STAR WASHER M6 STAR WASHER
Ø1/8" HOLES Ø1/8" HOLES
5/16" HEX BOLTS 5/16" HEX BOLTS
VEHICLE ROOF VEHICLE ROOF
FOOT BRACKET FOOT BRACKET
M6 CAGE NUT M6 CAGE NUT
5/16" FLAT WASHERS
5/16" FLAT WASHERS
5/16" SPLIT LOCK WASHERS 5/16" SPLIT LOCK WASHERS
5/16" HEX NUTS
5/16" HEX NUTS
Page 3 of 14