Steinbach APPcontrol Manual Original página 54

Installing the buoyancy aids
1. Remove the filters.
2. Remove the four screws on the top
part .
7
3. Take the top part
4. Stick two of the self-adhesive buoyancy
aids diagonally opposite each other
4
on the inside of the top part
Should the device still not float
sufficiently, stick on two additional
buoyancy aids next to the ones already
installed.
5. Replace the top part
down again with the four screws.
6. Now reinsert the filters.
The buoyancy aids are installed.
54
off.
7
.
7
and screw it
7
16
7
17
4