Troubleshooting - Steinbach APPcontrol Manual Original

Troubleshooting

Fault description
1H blinks rapidly and an alarm
is heard
All LEDs blink rapidly and a
buzzing sound is heard
1H+2H+3H blink rapidly and a
buzzing sound is heard
ALL+1H blink rapidly and an
alarm is heard
WALL+2H blink rapidly and a
buzzing sound is heard
FLOOR+3H blink rapidly and a
buzzing sound is heard
ALL+WALL+1H+2H blink rapidly
and an alarm is heard
WALL+FLOOR+2H+3H blink
rapidly and a buzzing sound is
heard
WALL+FLOOR+2H+3H blink
rapidly and an alarm is heard
WALL blinks rapidly and an
alarm is heard
The cable is twisted or tangled. The cable was not completely
52
Cause
The device is no longer in the
water.
Mains adapter is overloaded.
Seal of the motor unit is not
leak tight.
Pump is overloaded.
Drive motor 1 is overloaded.
Drive motor 2 is overloaded.
There is abnormal voltage in
the device.
Device is out of the water.
Device is out of the water and
could not be restarted.
Device has toppled over.
detached.
The cable in the water is too
long.
The device becomes stuck on
the drain grate.
Remedy
Place the device in the water
again or wait until the device
restarts automatically.
Contact customer service.
Stop the device and contact
customer service.
Stop the device and check the
wheel and the pump.
Check the drive belt.
Check the drive belt.
Stop the device and contact
customer service.
Stop the device, immerse it in
water and start the device
again.
Stop the device, immerse it in
water and start the device
again.
Manually set the device
straight again.
Switch off the device,
disconnect the cable and
untangle it.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
Switch off the filter system of
the pool.