Mercedes-Benz A0008901800 Manual De Instrucciones página 14

3
27
9
12
25
28
24
1. Position the bicycle centrally on rails (8) and secure it against tipping.
2. Place straps (12) around the bicycle frame at a suitable point, thread
them into bracket (9) and tighten them with lever (27) (arrow).
3. Lock bracket (9) with key (3). Remove key (3).
Note
Locking the bracket is only possible if the strap is correctly latched in
place. If necessary, pull on the strap to engage the latch.
Caution
Make sure the wheel holders engage when positioning them on the
rails.
4. Push the „PUSH" button and push the wheel holders on rails (8) onto
the tyres of the bicycle.
5. Feed strap (25) centrally between two wheel spokes in buckles (28)
and tighten with tensioner (24) (arrow).
Mounting a second bicycle
The second bicycle is mounted in the same way as the first. The two
bicycles must be fitted facing in opposite directions.
The second bicycle is fixed in place with long bracket (10).
Mounting a third bicycle
The third bicycle is mounted in the same way as the first. All bicycles
must be mounted facing in opposite directions.
The third bicycle is fixed in place with additional bracket (2) on the
second bicycle.
Caution
Remove bracket (2) from the rear-mounted bicycle rack if you are
not using it and store it away securely.
Removing bicycles
Follow the same steps in reverse order to remove the bicycles.
1. Rear-mounted bicycle rack for 3 bicycles
9
10
8
M+P-03F-8048
1
2
M+P-03F-8049
Pulling out/sliding back the rear-mounted bicycle rack
The rack can be pulled out to load and unload the vehicle.
G
WARNING
Pull the rear-mounted bicycle rack out slowly and ensure that there
are no persons or objects in the immediate vicinity. There is a risk of
trapping persons and objects in the immediate vicinity.
Pulling out the rear-mounted bicycle rack
8
1. Press lock (29) to the right.
Note
A red mark becomes visible to the left of the lock. The rack is unlocked
and can be pulled out.
2. Operate foot lever (30) and pull out rack (1) by pulling evenly on the
rack/bicycle frame.
Sliding the rear-mounted bicycle rack back in
Caution
Ensure that the lock springs back into place and covers the red
mark. This means that rack (1) is secured.
1. Slide rack (1) back in until it engages audibly.
2. Shake rack (1) to check that it is secured in place. If necessary, pull
rack (1) out and slide it back in again.
- 11 -
29
30
1
M+P-03F-8050