Flotec USKIT Instrucciones De Instalación

P.O. Box 342, Delavan, WI 53115
2196 1295
Figure 1
2197A 1295
Figure 2
OUT
Flow
2198A 1295
Figure 3 – Check the canister for the
filter ports marked "IN" and "OUT" to
insure proper flow direction.
Note: This drawing may not match your
installation.
PRINTED IN U.S.A.
Undersink Water Filter Installation Kit
®
Under Sink Installations
Step 1. Turn off cold water supply to faucet by closing shutoff valve located
under the sink. If your sink does not have a shutoff valve you will
need to turn off the water supply to the house. Cut the 3/8-inch cop-
per cold water line leading to the faucet and bend the ends slightly
apart (Figure 1).
Step 2. Insert the quick connect fittings onto each end of the copper line
and hand-tighten nut (Figure 2).
NOTE: Do not overtighten plastic fittings. Damage to the fittings
may occur and cause leakage.
Step 3. Mount the filter housing to the wall using screws supplied. Allow at
least 3" clearance under filter assembly for cartridge changing.
Insert the 3/8-inch plastic water line into each side of the filter
housing and into the quick connect fittings installed onto the copper
water line and hand-tighten nuts (Figure 3).
Step 4. Turn on the water supply and open the faucet. Thoroughly flush the
filter by running water for 2 minutes.
IN
MODEL USKit
INSTALLATION INSTRUCTIONS
FP375 (2/12/96)