Maintenance And Service - Federal Signal 450E Guia Del Usuario

Figure 4 Weatherproof mounting
BACKBOX
Weatherproof Panel Mounting
For horn installations that require a watertight seal
when mounted on panel, a flat rubber gasket is
supplied. See Figure 5.
Figure 5 Weatherproof panel mounting
GASKET
#8-32 x 1-5/8" SCREW (4)
IMPORTANT: For Type 4X or IP66 applications, the
surface must be flat and smooth, and all four screws
must be used.
To panel-mount the horn:
1. Mark the locations of the four mounting holes.
See Figure 6 on page 4 for measurements.
2. Drill a hole at each mark.
3. Using the dimensions in Figure 6, mark the
cutout for the horn and cutout the opening.
4. Remove any burrs, and smooth the edges of the
cutout.
5. Secure the horn and gasket to the panel with the
four supplied #8-32 x 1-5/8" screw and Keps
nuts. Torque the mounting screws 12 in-lb to
16 in-lb (1.4 Nm to 1.8 Nm).
Installation and Maintenance Instructions
Federal Signal signaling.fedsig.com
GASKET
SCREW
290A7586
#8-32 KEPS
NUTS (4)
PANEL
290A7588
®

Maintenance and Service

Technical Assistance: Contact our Technical Support
Team at +1 708-587-3587 or signalsupport@fedsig.
com.
Repair Service: A return authorization is required.
Contact your Authorized Distributor or Federal Signal
Customer Support. Defective products under warranty
will be repaired or replaced at Federal Signal's
discretion.
Product Returns: Returns require authorization from
Federal Signal. Contact your Authorized Distributor for
more information on our return policy or to request a
return.
3