Operational Safety Guidelines; Motorola Solutions Authorized Batteries - Motorola PMLN6685 Manual Del Usuario

OPERATIONAL SAFETY GUIDELINES

• Turn radio off when charging battery.
• This equipment is not suitable for outdoor use. Use only in dry
locations/conditions.
• Connect equipment only to an appropriately fused and wired
supply of the correct voltage (as specified on the product).
• Disconnect from line voltage by removing mains plug.
• The socket outlet to which this equipment is connected should
be close by and easily accessible.
• In equipment using fuses, replacements must comply with the
type and rating specified in the equipment instructions.
• Maximum ambient temperature around the power supply
equipment must not exceed 40 °C (104 °F).
• Output power from the power supply unit must not exceed the
ratings stated on the product label located on the bottom of the
charger.
• Make sure the cord is located where it will not be stepped on,
tripped over, or subjected to water, damage, or stress.
CHARGER SPECIFICATION
Input: 100–240 VAC~, 50/60 Hz, 600 mA
Output 1: DC 4.2 V
Output 2: DC 5 V

MOTOROLA SOLUTIONS AUTHORIZED BATTERIES

The batteries listed in Table 1 are approved for use with the
chargers listed in Table 2.
Table 1: Motorola Solutions Authorized Batteries
Kit Part Number
HKNN4013_
PMNN4425_
PMNN4468_
, 600 mA x 6 pockets
, 600 mA x 6 pockets
Battery Chemistry/Description
Li-Ion BT90, 1800 mAh
Li-Ion BT7X, 1370 mAh (SNN5876_)
Li-Ion BT100x, 2300 mAh
2