Metabo HPT NV 45AB2 Instrucciones Y Manual De Seguridad página 19

Main Nail Stopper
Nail Guide
Sub Nail Stopper
Feeder
4 Lubricate the feeding surfaces of the nose and
the nail guide after cleaning.
This promotes smooth operation and prevents
rust.
4. Cleaning and removal of tar and dirt.
Tar and dirt may build up on the nose and push lever.
This can prevent correct operation.
Clean and remove tar and dirt with kerosene, #2 fuel
oil or diesel fuel.
NEVER USE GASOLINE or other highly fl ammable
liquids.
Vapor of such liquids inside the Nailer could be
ignited by a spark produced during nailing, which can
cause an explosion.
1 Immerse only the area around the outlet in
solvent.
Do not immerse the magazine or body.
Plastic parts and O-ring may be damaged.
Body
Nose
Push
Lever
2 Dry off the Nailer before use. Any oil fi lm left after
cleanup will accelerate the tar buildup, and the
Nailer will requite more frequent re-cleaning.
3 Make sure the push lever operates properly.
Nose Opening
Feeder Shaft
Magazine
Outlet
● Never use Nailer unless push lever is
operating properly.
NOTE:
Solvents sprayed on nose to clean and free up the
push lever may have the opposite eff ect. The solvent
may soften the tar on the shingles and cause tar
buildup to be accelerated. Dry operation is better.
5. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove paper chips or
wooden chips which may have accumulated in
the magazine.
6. Storing
○ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
○ Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
7. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
Warning
Label
8. Maintenance chart (See page 20)
9. Operator troubleshooting (See page 21)
10. Service parts list
English
WARNING
19