Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
3 Turn the nail holder 90 degrees clockwise until
you hear "click".
For 7/8", 1" and 1-1/4"
(22 mm, 25 mm, 32 mm)
For 1-1/2" (38 mm)
For 1-3/4" (45 mm)
Plate
NOTE:
Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly closed
without adjusting the nail holder correctly, the nail
holder may be damaged.
(3) Place the nail coil into the magazine.
Insert the fi rst nail into the magazine opening.
Magazine Opening
First Nail
Nail
(4) Close the magazine cover.
(5) 1 Uncoil enough nails to reach the driving hole.
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole
First Nail
2
Nail Guide
14
Magazine
Nail Holder
3
1
2
Magazine
Guide Surface
Guide Slot
3
1
4
2
Feeder
Pawl
NOTE:
Be careful not to deform the collated wires and not to
disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
4 Pulling the nails to the right.
After checking and making sure that the magazine
cover is closed, hook your fi ngers on the nail
guide and knob, turn the nail guide clockwise
while pressing the knob downward, and then
close the nail guide completely.
Knob
4
Nail Guide
(6) Lock the knob completely.
The Nailer is now ready to operate.
NAILER OPERATION
Read section titled "SAFETY" (pages 4 – 8).
● Operators and others in work
● Only person who have read
● NEVER point tool at yourself
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
● Know and understand what trigger system
you are using.
Please read and understand "Methods of
Operation" below.
4
Magazine Cover
DANGER
area
MUST
wear
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
and
understand
MANUAL should operate the
Nailer.
or others in work area.
safety
this
Publicidad
Tabla de contenido
