Operation Modes; Mitre Cuts; Sliding Cuts - HOLZMANN MASCHINEN KAP305JL Manual De Usuario

16.3 Operation modes

16.3.1 Mitre cuts

Mitre are particularly suitable for cutting small workpieces (approx. 100 mm) to length.
 For cross-cut cuts, the sliding mechanism is fixed by the fixation screw (1) so that the saw
unit cannot slide forwards or backwards during the cut.
 Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.
 Mark the cutting line (by laser).
 Place workpiece against stop/fence and table and fix with the clamp device.
 Move the machine head to the uppermost position.
 Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),
 Make the crosscut (move the machine head downwards) until it has reached the lowest
position.
 Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply release the machine head, instead
move the handle upwards until the uppermost position is reached (rest position).
 Release the ON-OFF switch and wait until saw blade comes to stand still.
 Remove workpiece

16.3.2 Sliding cuts

Sliding cuts are suitable for cutting longer workpieces.
 For that kind of cuts, the sliding mechanism is unlocked by releasing the fixation screw (1) so
that the saw unit can slide forwards or backwards during the cut.
 Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.
 Mark the cutting line (by laser).
 Place workpiece against stop/fence and table and fix with the clamp device.
 Move the machine head to its uppermost position and pull the machine head towards you.
 Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),
 Make the cut (move the machine head downwards) until it has reached the lowest position
and then slowly push the machine head backwards to be able to machine the wide workpiece
over its entire length.
 Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply release the machine head, instead move
the handle upwards until the uppermost position is reached (rest position).
 Release the ON-OFF switch and wait until saw blade comes to stand still.
 Remove workpiece
HOLZMANN MASCHINEN GmbH
N O T E
N O T E
www.holzmann-maschinen.at
OPERATION
42
KAP305JL