Velleman VMB4RY Manual De Instrucciones página 4

1 Normal open contact channel 1
Normal open contact channel 2
2
3 Normal open contact channel 3
4 Normal open contact channel 4
5 12V supply
6 Velbus
7 Direct push button control for channel 1
Direct push button control for channel 2
8
Direct push button control for channel 3
9
10 Direct push button control for channel 4
11 Relay-ON indication LED channel 1
12 Relay-ON indication LED channel 2
Relay-ON indication LED channel 3
13
14 Relay-ON indication LED channel 4
Power LED
15
16 Reception LED
Forwarding LED
17
18 Termination
If the module is connected as the final device on the
VELBUS, place the 'TERM' jumper. Remove the
jumper in all other cases.
19 Operation mode LED channel 1
4
20 Operation mode LED channel 2
Operation mode LED channel 3
21
22 Operation mode LED channel 4
Operation mode indication :
The LED will not light if the relay is switched of.
The LED lights if the relay is witched on and the timer is
not activated.
The LED blinks rapidly if the timer is activated.
The LED blinks slowly if the 2
2-way timer mode.
The LED blinks fast if the module is activated in the
'learning' mode.
23 Manual control channel 1
24 Manual control channel 2
25 Manual control channel 3
26 Manual control channel 4
Adress setting
27
Enter a unique address (except for '81'... '84', '91'...
'94', 'A1'...'A4', 'B1' ... 'B4', 'C1' ... 'C4', 'D1' ... 'D4',
'E1' ... 'E4' and 'F1' ... 'F4') for each module.
Establish the module address as '00' if the Velbus will not be
connected (see connection diagram on page 31).
nd
timer is activated in the