Velleman VMB4RY Manual De Instrucciones página 7

The relay will be switched off and the operation mode LED will blink very rapidly to indicate the learning mode. The push
button LEDs which are saved in the non-volatile memory will also blink very rapidly. In this way it is possible to see which
push buttons for the corresponding group have already been learned.
You can add a specific push button by maintaining it pressed until the relay switches on. When releasing the push button the
relay will switch off and the push button indication LED will blink very rapidly as a confirmation. If this does not work then the
maximum amount of push buttons has been reached.
To delete a learned push button, maintain it pressed. When releasing the push button the indication LED will be turned off.
You can delete all learned push buttons for a specific control group by maintaining the manual control on the relay module
pressed until the relay switches on. When releasing the manual control push button the relay and the indication LEDs of all
corresponding push buttons will turn off.
Quit the learning mode by resetting the relay module's original address.
7