Horizon Global 76226 Instrucciones De Instalación página 9

5. Remove bumper beam:
All models - Disconnect the sensor wiring and plastic rivet attached to the bumper beam.
2018 – current models, using a 13mm socket, remove (2) hex nuts holding exhaust hanger brackets to bottom of bumper beam, (1) per side.
All models, using an 18mm deep well socket with 6" extension, remove (4) hex flange nuts holding bumper beam to end panel, (2) per side. See Figure 1.
2011 – 2017 models – Remove the foam gasket from between aluminum bumper and end panel.
2018 – current models - Keep foam gasket on end panel. If foam gasket is damaged, apply silicone sealant (not provided) to hitch bracket mounting surfaces.
©2018 Horizon Global™ Corp - Printed in Mexico Sheet 9 of 33 76226NP 03-23-18 Rev. A