Service And Maintenance - Cub Cadet CC30H Manual Del Operador

Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all moving parts
have come to a complete stop. Disconnect spark plug wire and ground it against the engine to prevent unintended starting.
Always wear safety glasses during operation or while performing any adjustments or repairs.
Follow the maintenance schedule given below. This chart describes service guidelines only.
Check/Clean Engine Intake Screens & Cooling Fans *
Check/Clean Exhaust Manifold, Muffler Pipe & Muffler
Shields *
Check/Clean Hood/Dash Panel Louvers *
Check/Clean Top & Underside of Deck, Under & Around
Spindle Covers & Belt Area *
Check/Clean Around Fuses, Wiring & Wiring Harnesses *
Check/Clean Around Transmission, Axle and Fans *
Check Engine Oil Level
Check Air Filter for Dirty, Loose or Damaged Parts
Clean & Re-oil Air Filter's Foam Pre-cleaner (If equipped)
Replace Air Filter Element
Change Engine Oil & Replace Oil Filter (If equipped)
Lube Front Axles & Rims
Check Spark Plug Condition & Gap
Replace Fuel Filter
* -- Perform more often in dry conditions and/or when mulching.
IMPORTANT! It is important to consult the specific Engine
Operator's Manual included with this machine for detailed
engine maintenance procedures and intervals.
NOTE: This Operator's Manual covers several models. Riding
mower features may vary by model. Not all features in this
manual are applicable to all riding mower models and the riding
mower depicted may differ from yours.
Post-Operation Rider Care
After each operation of the rider, the following procedures
should be implemented to extend the life of your rider and
ensure safe operating conditions.
Failure to follow these recommendations may result in
serious injury to yourself or others and may cause damage
to the rider.

SERVICE AND MAINTENANCE

WARNING
WARNING
Before Every Every
Each Use 10 Hours 25 Hours
P
P
P
P
P
P
P P
P
CLEANING THE UNDERSIDE OF THE DECK
Deck Wash System (if equipped)
Your rider's deck may be equipped with a water port on its
surface as part of its deck wash system.
Use the Smart Jet to rinse grass clippings from the deck's
underside and prevent the build-up of corrosive chemicals.
Complete the following steps AFTER EACH MOWING:
1. Drive the rider to a level, clear spot on your lawn, near enough
for your garden hose to reach.
Make certain the rider's discharge chute is directed AWAY
from people, your house, garage, parked cars, etc.
2. Disengage the PTO, set the parking brake and stop
the engine.
3. Thread the hose coupler (packaged with your rider's
Operator's Manual) onto the end of your garden hose.
4. Attach the hose coupler to the water port on your deck's
surface. See Figure 20.
20
Every Every
50 Hours 100 Hours
P
P
P
P
P
P
WARNING
Prior to
Storing
P
P
P
P
P
P
P
P