Honda 600MH Instrucciones De Operación / Seguridad página 17

3.3 Using the distance guide
The Perimeter Wire Machine 600MH
adjustable distance guide. This is used
to align the machine with the edge of
the course and
FRONT
bury the wire at a
distance between
15 cm and 45 cm.
In addition, the
distance guide
can be placed at
the front or back
B
of the machine,
depending on user
preference.
To use the distance guide:
1) Unscrew the wing nut (See A);
2) Position the distance guide at the desired distance according to
the ruler label (on the front or back of the machine). The ruler
ensures positioning between 15 and 45 cm to the nearest
centimeter. (See B);
3) Tighten the wing nut.
3.4 Self-propulsion
The Perimeter Wire Machine 600MH
equipped with a transmission for selfpropulsion.
This allows for a constant rate of installation
and considerably reduces operator effort.
3.5 Inserting the perimeter wire in the wire guide
Proceed as follows:
1) Pull the end of the wire from the spool;
2) Insert the wire in the guide wire tube;
3) Push the wire until it emerges;
3.6 Burying the perimeter wire in the ground
Refer to the manufacturer's instructions of the robot mower for the
technical specifications for installing perimeter wire.
Initially, attach the end of the wire to a stake or a tool planted in the
ground.
1) Start the engine;
2) Lift the support foot at the front of the machine;
3) Slowly insert the blade into the ground by pressing down on the
handle until the frame is parallel to the ground (Figure 1);
TM
is equipped with an
BACK
TM
is
4) Apply pressure to the traction handle to move
the machine (Figure 2)..
B
1
A
3.7 Adjusting the handle height
It is important to adjust the handle height
before working with the Perimeter Wire
TM
Machine 600MH .
3.8 Overcoming obstacles in the ground
When burying the wire in the ground, some immovable obstacles such
as large rocks or roots will be encountered. To avoid damage to the
blade and/or the machine, follow the instructions below:
1) Release the traction handle (Figure 1);
2) Push the handle upwards, trying to keep the blade and
the wire guide in the soil (Figure 2, A);
3) Lightly press on the traction handle to pass over the
obstacle (Figure 2, B);
4) Lower the machine so that the frame is parallel to the
ground (Figure 3, A);
5) Resume the job by pressing the traction handle
(Figure 3, B).
1
3.9 Insertion of perimeter wire in a tight corner
When designing the Perimeter Wire Machine 600MH
feature has been implemented to allow burying of the wire as close
as possible to the perimeter of the field and to avoid having to
2
The recommended handle position is at the
waist level, but adjust it to your preferred
height using the handle clamping lever.
DO NOT PUSH THE BLADE AGAINST THE OBSTACLE IN AN
ATTEMPT TO TRY TO CUT OR DISPLACE IT.
A
B
2
EN
A
B
3
TM
, every
5 5