Belt Adjustment - Honda 600MH Instrucciones De Operación / Seguridad

manually bury the wire. Its compact size and the 15 cm blade offset
from the outside of the wheel are good examples. The handle is also
designed to quickly and easily pivot as needed to turn tight corners.
Follow the steps below•:
4
4) Turn the machine in the desired direction by grasping the arch;
5
6
7
1
1) Move as far as possible
into the corner (See
distance recommended by
the manufacturer);
2
2) Loosen the clamping lever
on the handle;
3
3) Lift the handle
vertical;
5) Lower the handle until
horizontal;
6) Place your left hand on the
arch and your other hand
on the lever, to move the
machine to free from the
corner and to able to
resume the normal working
position (press on the
traction handle to move);
7) Once out of the corner,
move the handle to the
desired position to continue
burying the wire.
3.10 Transport
The best way to transport the 600MH
is to fold the handle forward parallel to
the ground. With the foot stand folded,
tilt the machine down until the handle
is on the floor of the transport vehicle.
Secure it with a ratchet strap. Make
sure the gas tank valve is turned off.
If transported inside a vehicle, keep in
mind that there will be some fuel vapors
release thru the gas tank breather cap. Vapors can be stopped by
placing a plastic film temporarily between the cap and the gas tank.
4. Maintenance
Some adjustments should be performed periodically to maintain the
machine in good working condition. Here is the maintenance
schedule•:
ACTION
Check the blade
attachment
until
Check the wire guide
attachment
Check the tire pressure
Check the oil level
Check the blade
Clean the top and bottom
of the machine
Clean underneath the
guards
Clean the blade
attachment system
Clean the inside of the
wire guide
Clean the tires
Lubricate the blade
transmission shaft
Inspect and adjust the
belts
Inspect and tighten bolts
and nuts
Check the engine by the
Honda manual
4.1

Belt adjustment

The Perimeter Wire Machine 600MH
belts. These should be inspected and/or adjusted every twenty five
(25) hours of use. In some cases, they should be replaced. The main
reasons for replacing a worn belt are: cracking, loss of material,
unraveling, uneven wear or areas shiny due to heat or slippage.
NOTE: Do not overtighten the belts! The belt should move about 1cm
when pressure is applied in the middle of the span.
BEFORE / EVERY
10 25 100
Use Storage
hours hours hours
X
X
X
X
X X
X X
X X
X X
X X
X X
X
X X
X X
X X X
TM
is equipped with three (3)
EN
AFTER
Use
X
X
X
X
X
6 6