Operation (continued)
6
Adjusting the ON-TIME Switch
The "ON-TIME" switch determines the amount of time
the light will stay on full bright after all motion has
stopped.
Set the "ON-TIME" switch to the 1, 5, or 20
minute position.
TEST 1 5 20
MINUTES
ON-TIME
7
Manual mode overrides the motion sensor (C) and
"ON-TIME" control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (C) will reset to motion
sensing mode after 6 hours or sunrise, whichever
comes first. Manual mode can be toggled on and off
using a wall switch.
C
Turn the switch
OFF for 3 to 4
10
Using Manual Mode
To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
seconds
Turn the
switch
back ON