Installation - Defiant DF-5311-BZ-D Guía Para El Uso Y Cuidado

Installation

1
Drilling Canopy Holes
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
Remove the existing light fixture.
Determine which of the knockouts need to
be used to match the mounting holes on the
junction box.
If needed, drill the necessary holes into the
canopy (B) using a drill (not included) and a
3/16" (5 mm) drill bit (not included).
3
Wiring the Light Fixture
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
Route the light fixture wires through the large
hole in the gasket (FF).
Connect the light fixture wires to the junction
box wires with wire connectors (AA):
White to white
Black to black
Bare or green ground wire to house ground
AA
B
AA
Attaching Bulb Holder to
2
Fixture Arm
Pull the bulb holder (A) wires through the
canopy (B) while placing the bulb holder (A)
and fixture arm (3) together. Make sure none of
the wires are pinched between the two pieces.
Make sure the gasket (4) is properly placed
between the bulb holder (A) and fixture arm (3)
and secure with bolt (BB).
4
Mounting the Light Fixture
Align the drilled holes on the canopy (B) with
the holes on the junction box.
Secure the canopy (B) to the junction box using
the mounting screws (CC, DD, or EE) that best
fit the junction box. Do not overtighten.
NOTE: Make sure all the wires are inside the junction box
before attaching the canopy (B) to the junction box.
6
A
BB
3
B
CC, DD, or EE
4
B